Leuze electronic CML 720i Ex - Interface and Mounting Accessories

Ordering information and accessories
Leuze electronic CML 720i Ex 135
17.2 Accessories – CML 720i Ex with CANopen or IO-Link interface
1 Y-interconnection cable (transmitter – receiver synchronization (X1/X3) + power), see table 17.3
2 Connection cable (PWR IN/Digital IO), see table 17.4
3 CANopen Y-interconnection cable X2 (BUS IN/BUS OUT), see table 17.5
4 CANopen terminating resistor, see table 17.6
5 CANopen interconnection cable, see table 17.7
Figure 17.1: CANopen/IO-Link interface
CML730i-T20-2720.A-
M12
CML 730i, transmitter, beam spacing 20 mm, measurement field length
2720 mm, axial connector outlet, M12 connector
CML730i-R20-2720.R/
PB-M12
CML 730i, receiver, beam spacing 20 mm, measurement field length 2720 mm,
rear connector outlet, PROFIBUS interface, M12 connector
CML730i-R20-2720.R/
D3-M12
CML 730i, transmitter, beam spacing 20 mm, measurement field length
2720 mm, rear connector outlet, RS 485 Modbus interface, M12 connector
Part designation Properties
For devices with IO-Link interface, the X2 connection on the receiver is not assigned.
The Y-fieldbus cable (3) is not required.
1 1
2 235 3 4