What to do if Leuze electronic Security Sensors display error F4?
If your Leuze electronic Security Sensors display error F4, it indicates an internal hardware fault. The suggested solution is to send the device in.
What to do if Leuze electronic SD4T 14 Security Sensors display error F36?
If your Leuze electronic Security Sensors display error F36, it means the test identification signal from the transmitter is longer than 3 seconds. Check the transmitter test input.
What to do if LEDs and 7-segment displays are not lit on Leuze electronic SD4T 14?
If the LEDs and 7-segment displays are not lit on your Leuze electronic Security Sensors, it could be due to the 24 V DC supply voltage. Check the connecting cable. If that's not the issue, replace the receiver if necessary.
What to do if Leuze electronic SD4T 14 Security Sensors display error F35*?
If the Leuze electronic Security Sensors display error F35*, it means the start/restart button was pressed for longer than 10 seconds. Check the start button wiring.
What to do if Leuze electronic SD4T 14 display error F6*?
If your Leuze electronic Security Sensors display error F6*, it indicates a short circuit between ground and OSSD1 or a cross circuit. To resolve this, remove the short circuit, overload, or cross circuit. Then, turn the supply voltage off and on again.
What does it mean if LED1 is lit red continuously on Leuze electronic SD4T 14 Security Sensors?
If LED1 is lit red continuously on your Leuze electronic Security Sensors, it indicates a hardware error. The suggested solution is to replace the transmitter.
Why is the LED not lit on my Leuze electronic Security Sensors?
If the LED on your Leuze electronic Security Sensors is not lit, you should: 1. Check the supply voltage. 2. Check the connecting cable. 3. Replace the transmitter if necessary.
What to do if Leuze electronic Security Sensors display error F37*?
If the Leuze electronic Security Sensors display error F37*, it indicates an EDM configuration error. To solve this, check the EDM wiring and then turn the supply voltage off and on again.
What to do if Leuze electronic Security Sensors display error F26*?
If your Leuze electronic Security Sensors display error F26*, it indicates that different evaluation procedures (SCAN) were discovered during operation. To resolve this, switch the supply voltage off and on again.
What to do if Leuze electronic SD4T 14 Security Sensors display error F33*?
If your Leuze electronic Security Sensors display error F33*, it means the EDM operating mode changed during operation. To resolve this, switch the supply voltage off and on again.
General| Brand | Leuze electronic |
|---|---|
| Model | SD4T 14 |
| Category | Security Sensors |
| Language | English |
To Next Page
