What to do if Leuze electronic Security Sensors display error F32*?
If your Leuze electronic Security Sensors display error F32*, it means the RES operating mode changed during operation. To fix this, switch the supply voltage off and on again.
What to do if Leuze electronic Security Sensors display error F25*?
If your Leuze electronic Security Sensors display error F25*, it indicates that different transmission channels were discovered during operation. To resolve this, switch the supply voltage off and on again.
What to do if Leuze electronic SD4T 14 display error F30?
If your Leuze electronic Security Sensors display error F30, it indicates an error in the semiconductor test (timeout or multifuse). Turn the supply voltage off and on again. If the error occurs again, the device should be sent in.
What to do if Leuze electronic SD4T 14 display error F9?
If your Leuze electronic Security Sensors display error F9, it means there is an OSSD short circuit after VCC or a cross circuit on output 2. Remove the short circuit after VCC or cross circuit. If the error occurs again, the device should be sent in.
What to do if Leuze electronic Security Sensors display error F7?
If your Leuze electronic Security Sensors display error F7, it means there is an OSSD short circuit after VCC or a cross circuit on output 1. Remove the short circuit after VCC or cross circuit. If the error occurs again, the device should be sent in.
What to do if Leuze electronic Security Sensors display error F10?
If your Leuze electronic Security Sensors display error F10, it indicates undervoltage on the power supply. Check the power supply and feed to resolve this issue.
What to do if Leuze electronic SD4T 14 Security Sensors display error F34*?
If the Leuze electronic Security Sensors display error F34*, it means the EDM timeout has been exceeded because the feedback circuit either closes or will not open. To fix this, check the EDM wiring and then turn the supply voltage off and on again.
What to do if Leuze electronic SD4T 14 display error F8*?
If your Leuze electronic Security Sensors display error F8*, it indicates a short circuit between ground and OSSD2 or a cross circuit. To resolve this, remove the short circuit, overload, or cross circuit. Then, turn the supply voltage off and on again.
General| Brand | Leuze electronic |
|---|---|
| Model | SD4T 14 |
| Category | Security Sensors |
| Language | English |
To Next Page
