Mounting
Leuze electronic MLC 520 30
The wall mounting through threaded holes makes it possible to lift the mounting bracket after the screws
have been loosened over the connection cap. Therefore, the mounting brackets do not need to be removed
from the wall when exchanging the device. Loosening the screws is sufficient.
For increased mechanical loads, mounting brackets are also available in a vibration-damped version
(BT-2HF-S) (see chapter 15 "Ordering information and accessories").
Fig.6.8: Mounting via BT-R swivel mount
6.2.5 Fastening via swiveling mounting brackets
Fig.6.9: Mounting via swiveling mounting brackets
For larger protective field heights > 900 mm, the use of the BT-2SB10 swiveling mounting brackets is rec-
ommended (Ordering information and accessories). For increased mechanical requirements, these are
also available as vibration-damped version (BT-2SB10-S). Depending on the installation situation, environ-
mental conditions and protective field length (> 1200 mm), other mounting brackets may also be neces-
sary.
6.2.6 One-sided mounting on the machine table
The safety sensor can be mounted directly on the machine table via an M5 screw on the blind hole in the
end cap. On the other end, a BT-R swivel mount can be used, for example, so that turning movements for
alignment are possible despite the fact that the sensor is mounted on one side. The full resolution of the
safety sensor is thus preserved on all points of the protective field down to the machine table.
To Next Page
Loading...
