Starting up the device - Basic configuration
Leuze electronic GmbH + Co. KG CML 720i 71
Select Digital IOs > IO Logic > Positive PNP.
Select Digital IOs > IO Pin 2 > IO Function > Area Output.
Select Digital IOs > IO Pin 2 > Inversion > Inverted.
Select Digital IOs > IO Pin 2 > Area logic > OR.
Select Digital IOs > IO Pin 2 > Start Beam > 001.
Select Digital IOs > IO Pin 2 > End Beam > 032.
Configuration of pin 2 as PNP warning output
The following example shows the configuration of pin 2 as PNP warning output.
Select Digital IOs > IO Logic > Positive PNP.
Select Digital IOs > IO Pin 2 > IO Function > Warn Out.
Configuration of pin 2 as PNP trigger input
The following example shows the configuration of pin 2 as PNP trigger input.
End beam 32
Switch-on condition 1 beam interrupted
Switch-off condition 0 beams interrupted
OR
Level 0 Level 1 Level 2 Description
Digital IOs
IO Logic Positive PNP Negative NPN
IO Pin 2
IO Function Trigger In Teach In Area Out Warn Out Trigger Out
Inversion Normal Inverted
Teach height Execute Exit
Area logic AND OR
Start Beam 001
End Beam 032
Level 0 Level 1 Level 2 Description
Digital IOs
IO Logic Positive PNP Negative NPN
IO Pin 2
IO Function Trigger In Teach In Area Out Warn Out Trigger Out
Inversion Normal Inverted
Teach height Execute Exit
Area logic AND OR
Start beam (enter value)
End beam (enter value)
Level 0 Level 1 Level 2 Description
Digital IOs
IO Logic Positive PNP Negative NPN
IO Pin 2
IO Function Trigger In Teach In Area Out Warn Out Trigger Out
To Next Page
