SECTION 8: CONNECT TO WI-FI
The Freezer Sentry device is immediately ready to join your 2.4 Ghz Wi-Fi network
after power up. When the Freezer Sentry has not been configured to a Wi-Fi
network the Cloud LED will display as WHITE, and the access point is active (the
unit will broadcast its Level Sense Wireless Network. Refer to section 6).
There are a series of articles on more advanced troubleshooting for WI-FI
connections under the Troubleshoot section which is found on the upper banner of
the website.
iii. To mount with the included screw, insert the
screw into the hole on the hook sensor, and
carefully tighten the screw to the printed
circuit board.
Password Requirements for Your Local 2.4Ghz Wi-Fi Network:
SSID (Local Network Name) and Password are Case Sensitive You must have a
password 8 - 48 Characters in Length. The following Characters are not supported
in Wi-Fi Passwords or network names at the moment: <> \ ^ ' { } “ %
THIS APPLIES TO CONNECTING WITH WPS OR CONNECTING WITH HOTSPOT!
To Next Page
Loading...
Need help?
General
