d. Once complete, you can enter your Level Sense account email address into the
email address field (If you do this, the device will automatically link to your
account, and you will NOT be presented with a claim code). Lastly, press the
submit button.
e. The webpage then instructs you to click the RESET button on the Freezer Sentry.
After restarting, the Cloud LED will pulse yellow until it connects to your Wi-Fi.
Upon successful connection the device will either…
i. Present a claim code (all four LEDS on the device will blink in unison (Proceed
to Section 9)
ii. The Cloud LED will change to pulsing blue, followed by blue on the other 3
LEDs (Proceed to Section 10). This indicates that the device has been
successfully linked to your account, and no claim code is needed.
iii. The Cloud LED changes to red (No local internet connection). This can be
caused by an incorrect password for the Wi-Fi network, or the network is out
of range. If this happens, press the RESET button to try again. If it does not
connect on subsequent attempts, please reference Section 13 for instructions
on how to perform a password reset.
To Next Page
Loading...
Need help?
General
