Connects to audio input devices, such as a microphone with
built-in amplifier, etc. See How to Connect Audio In Device on
page 23 for more information.
NOTE: The microphone must have a built-in amplifier.
Connecting an ordinary microphone will dwarf sounds and will
result in inaudible recording.
Connects to a network using an Ethernet cable with RJ-45
connector.
Restores the factory default settings of the camera. To reset the
camera, while the power is on, press and hold the Reset Button
for at least 5 seconds or until the Blue LED lights up.
Insert a memory card (not included) into the slot for local
recording purposes. See How to Install / Remove the Memory
Card on page 21 for more information.
NOTE: Supports only microSDHC and microSDXC cards.
To Next Page
Loading...
