Levoit Dual 150 LUH-D302-WEU - Getting Started; Filling & Refilling

EN
8
GETTING STARTED
1. Remove all packaging.
2. Take the water tank o of the base and
remove all tape. Figure 1.1
3. Rinse and reassemble all parts before first use
(see Cleaning, page 9).
Figure 1.3
Figure 1.1
Figure 1.4
Figure 1.5
Figure 1.2
Note:
• Check to make sure that the water lter
is correctly in place. If not, then rotate
the lter clockwise to secure it in place.
Figure 1.2
4. Choose a hard, flat location for the humidifier
at least 30 cm / 12 inches away from any
walls. The surface must be water-resistant.
Figure 1.4
5. Mist should be directed away from walls,
furniture, bedding, and appliances. Figure 1.5
• Check to make sure that the oat is
securely in place. Figure 1.3
Filling & Refilling
1. Turn the humidifier o.
2. Remove the water tank cover by holding the
nozzle and pulling upward. Figure 1.6
3. Fill the tank with room-temperature water.
Figure 1.7
Figure 1.6 Figure 1.7
4. Replace the water
tank cover.
Note:
• We recommend using puried or distilled water
to ll the tank.
• Do not ll past the tank’s max water line.
• Do not ll with hot water.
Figure 1.8 Figure 1.9
• Do not add water directly into the base
chamber. Figure 1.8
• Do not add water through the mist tube.
Figure 1.9
CAUTION
Note: Make sure the water tank is clean before lling.
Figure 1.10
Note: Make sure the
nozzle on the water tank
cover is placed over
the mist tube, or the
humidier may not work
correctly. Figure 1.10
12 in /
30 cm
12 in /
30 cm