8
Air Purifier Placement
Clean Air Delivery Rate
Adding Essential Oils
Humidity
For highest eciency of air purification,
make sure that airflow isn’t obstructed. To
allow air to circulate freely in and out of the
air purifier, there should ideally be
15 inches / 38 cm of clearance on all sides
of the air purifier. Avoid placing too near a
corner or too close to a wall. Keep away
from curtains and anything that might block
airflow.
This air purifier has a Clean Air Delivery
Rate of 75 cubic meters per hour.
Clean Air Delivery Rate (CADR) measures
the eciency of an air purifier by indicating
the volume of clean air that an air purifier
produces. This is based on the removal
of dust, pollen, and smoke, which are the
3 most common indoor air pollutants. The
higher the CADR, the more particles the air
purifier will remove and the larger the area it
can clean. The rating is measured at the air
purifier’s highest speed.
Moisture may damage the filters. This air
purifier should be used in an area with a
humidity level below 85% RH. If you use the
air purifier in excessively humid areas, the
surface of the filters will become moldy.
Note:
Water or moisture will allow mold
to grow. To solve a mold problem, get
rid of the source of the moisture and
clean up the mold.
Note: Do not
mix essential oil blends.
Clean the aroma pad before using a
new essential oil blend (see Cleaning
the Aroma Pad
, page 10).
Note:
Essential oils are not included.
Essential Oils
Do not add essential oils to the filters or the
fan. The filters will be damaged by the oil
and will eventually release an unpleasant
smell. Only add essential oils to the aroma
box at the top of the air purifier.
USING YOUR AIR PURIFIER CONT.
1. Remove the aroma box cap.
2. Add 2–3 drops of the essential oil to the
aroma pad.
3. Replace the cap.