12
USING YOUR SMART HUMIDIFIER
1. Plug in the humidifier. The indicators
on the display will light up for 1 second,
then turn o.
2. Tap to turn your humidifier on. The
humidifier will start misting.
Note:
Using the VeSync app allows you to control
your smart humidifier remotely and access additional
functions and features (see page 11).
Note:
You can also set the humidifier to
automatically stop misting when the room
reaches a specific humidity level (see Auto
Mode, page 12).
Auto Mode
Figure 2.1
Figure 2.2
Note:
• During first use, the humidifier may take
10–25 seconds to start misting.
• If there is no water in the tank, will
flash 10 times, and the humidifier will
turn o. Fill the water tank (see Getting
Started, page 9).
Note:
• Direct the nozzle away from any
furniture, walls, or other objects to
prevent them from getting wet.
• Do not inhale the mist directly from the
nozzle.
3. Tap repeatedly to cycle through
mist settings: Low, Medium, and High.
[
Figure 2.1
]
4. Rotate the nozzle to adjust the direction
of the mist. [
Figure 2.2
]
5. Optionally, use the controls or the
VeSync app to turn on Auto Mode,
activate Sleep Mode, and more (see
Controls, page 8).
6. When your room has reached your
preferred humidity level, turn the
humidifier to a lower setting, or turn it o.
A comfortable humidity level is between
40–60%.
7. Tap to turn your humidifier o.
Low Mist
Medium Mist
High Mist
Auto Mode uses the humidifier’s sensor
to automatically adjust the mist level to
maintain a target humidity level. The default
target humidity level is 60%.
Note:
The humidifier will automatically mist
for 15 seconds after being turned on, even
if the room has reached the target humidity
level.
1. Tap to turn Auto Mode on.
2. By default, Auto Mode uses Automatic
Stop. The humidifier will stop misting
when the highest target humidity level is
reached (default 60%).
To Next Page
Loading...
