Levoit OasisMist 1000S - Auto Mode and Target Humidity Settings; Sleep Mode and Display Control

13
Room
Relative Humidity *
Automatic
Mist Level
Under 50%
High
50–55%
Medium
55–60%
Low
Over 60%
Automatic Stop
Setting Target Humidity
You can set a target humidity level from
40–80%, in increments of 10%. There are
several ways to change the target humidity:
*If you change the target humidity from
60%, the humidity percentages will change
accordingly.
• Change the target humidity in the
VeSync app.
• Press on the remote control.
Continue pressing to cycle through
target humidity options.
• Tap to turn Sleep Mode on/o.
• When Sleep Mode is on, you can
tap any button to wake up the
display. If you stop touching the
display, the display will turn o
again after 6 seconds.
• Once you wake up the display, tap
any button again to exit Sleep Mode
and resume manual controls.
• To turn o the display, press and
hold for 3 seconds, or press
on the remote control.
• To turn the display back on, tap any
button.
• Press and hold on the control
panel until the display flashes and
shows the target humidity. Continue
tapping to cycle through target
humidity options.
3. The humidifier will continue detecting
the humidity level in the room. It will
start and stop misting again according
to the following table:
AUTO MODE (CONT.)
Note:
• In the VeSync app, you can turn
Automatic Stop on/o.
• If Automatic Stop is o, the humidifier will
keep running on low mist level when the
highest target humidity level is reached.
Sleep Mode
Turning Off the Display
Sleep Mode changes the humidifier’s mist
setting to low and turns o the display lights.
The display will automatically dim after 3
seconds of inactivity.