Levoit OasisMist 1000S - Final Assembly Steps

20
Replacing the Remote Control
Battery
1. Follow the cleaning instructions (see
page 16) and allow all parts to dry
completely before storing.
2. Wrap the power cord around the cable
winder.
3. Store in a cool, dry location.
1. Remove the battery compartment by
pinching the tab in and pulling the
compartment out. [ Figure 9.1 ]
2. Remove the old battery
3. Replace with a new 3V CR2025 battery.
Make sure the polarities match.
4. Replace the battery compartment.
Storing
3. Flip the water inlet tank over and
replace the muer. [ Figure 8.3 ]
Figure 9.1
Figure 8.3
4. Place the water inlet tank in the
humidifier base and replace the top
cover.
5. Place the humidifier base properly on
the water tank.
6. Refill the tank, if necessary.
REASSEMBLING (CONT.)
Pinch
Pull out