Lexicon PCM NATIVE - Graphic Display; Early;Late Selectors; EQ Type Selector; Level Control

7
Graphic Display
Shows the EQ in a graphic form. The active section (Early or Late) is in the forefront.
Early/Late Selectors
These buttons select which EQ section is currently being edited. ‘Early’ includes
reections, direct echo outputs and room patterns. ‘Late’ includes the reverb tail.
EQ Type Selector
Allows any of six types of EQ to be applied to the active section. Those types are:
Single-pole lowpass (6db / Octave)•
Single-pole highpass (6db / Octave)•
Double-pole lowpass (12db /Octave)•
Double-pole highpass (12db / Octave)•
Bandpass•
Notch•
Level Control
Overall output level of the active section. These may be edited by holding the
mouse down and moving up and down over the knob. Alternatively, the value
eld may be directly edited.
EQ Parameters
Frequency, shelf and bandwidth parameters of the active section. To edit these,
click and hold on the knob, then move the mouse up or down. Alternatively, the
value eld may be directly edited. The bandwidth knob is only available when the
lter type is Bandpass or Notch.