Lexicon Prime Time 93 - Operation and Applications; The Basics: Straight Delay

•
14
the inputs without being aware
of it, since there are no input
overload indicators.
Additional outputs are the INPUT MIXER OUT which comes from the INPUT MIX
MASTER control, the DELAY A OUTPUT and the DELAY B OUTPUT. Delay A and B
outputs each
have level adjustments for peak output levels anywhere from
+8 to +18 dBm. These additional outputs are single-ended (unbalanced) and
can also drive 600 ohm loads.
Three functions
can be controlled externally via rear panel jacks. Delay
Bypass can be activated by a closure to ground through the DELAY BYPASS
jack using a single pole, single throw switch. External delay adjustment
can be achieved by plugging a 50k ohm potentiometer or a 0 to lOV source
(including a function generator source) into the
EXTERNAL DELAY jack. And
a closure to ground, using a normally open momentary switch, through the
REPEAT HOLD jack will enable or disable the REPEAT HOLD function.
I~
·-
·-
-
-
-
-
-
-
-
-
-
-