Error codes Error message Solution
59 Incompatible tray [x].
1 Turn o the printer, and then
unplug the power cord from the
electrical outlet.
2 Remove the indicated tray.
3 Connect the power cord to the
electrical outlet, and then turn on
the printer.
CAUTION—SHOCK
HAZARD: To avoid the risk of fire or
electrical shock, connect the power
cord to an appropriately rated and
properly grounded electrical outlet
that is near the product and easily
accessible.
61 Defective disk. Replace the defective storage drive.
62 Disk full. Try one or more of the following:
• To uch Continue to clear the
message.
• Delete fonts, macros, and other
data stored in the printer hard
disk.
• Install a printer hard disk.
63 Format the disk. Formatting now wipes all information
from the storage drive.
To format the storage drive later, do
the following:
1 From the home screen, touch
Settings > Device >
Maintenance > Out of Service
Erase.
2 Touc h Sanitize all information
on hard disk, and then touch
ERASE.
80.01, 80.09 Maintenance kit nearly low. To uch Continue to clear the
message.
80.11, 80.19 Maintenance kit low.
80.21, 80.29 Maintenance kit very low.
80.31 Replace maintenance kit,
recommended life exceeded.
See
“Ordering a fuser maintenance
kit” on page 121.
82.00, 82.02, 82.09 Waste toner bottle nearly
full.
Tou ch Continue to clear the
message.
82.12, 82.13, 82.19, 82.20, 82.22,
82.23, 82.29
Waste toner bottle almost
full.
82.30, 82.30, 82.33, 82.39, 82.40,
82.42, 82.49
Replace waste toner bottle. See
“Replacing the waste toner
bottle” on page 144.
Troubleshoot a problem 169
To Next Page
Loading...
