Lexmark C925 Print Defects Guide

Print defects guide
Repeating defects measurements
Match a set of repeating defects on a print job to the marks on one of the vertical lines. The line that best matches the defects
on the print job indicates which particular part is causing the defect.
Note: Make sure the current selection in the printer for Scale to Fit in the PDF menu is set to No for the rulers to be printed at
the correct size.
Change the imaging unit if the repeating defects appear in these
instances:
• every 41 mm (1.61 inches) of the page
• every 75 mm (2.95 inches) of the page
Note: The printer has four imaging units. Replace the imaging
unit that has the same color as the repeating print defect.
Change the fuser if repeating
defects appears on every
141 mm (5.55 inches) of the
printed page.
Change the transfer module if
repeating defects appears on
every 38 mm (1.5 inches) of the
printed page.
Print defects guide
Page 1 of 1

Lexmark C925 Specifications

General

Security algorithms	802.1x RADIUS, LEAP, MD5, PEAP, SSL/TLS
Networking standards	IEEE 802.3, IEEE 802.3ab, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Network connection type	Ethernet LAN
Supported network protocols	TCP/IP IPv4, IPX/SPX, AppleTalk, LexLink (DLC), TCP/IP IPv6, TCP, UDP
USB 2.0 ports quantity	-
Ethernet LAN (RJ-45) ports	1
Internal	Yes
Product color	Green, Silver
Package weight	1500 g