Updating the network license
Using the Embedded Web Server
1 Click Solutions.
2 Under Installed Solutions, click the appropriate application link.
3 Click License > Update License.
4 Select Network.
5 Click Update License.
Using MarkVision Professional
1 In MarkVision Professional, select the device where the application is installed.
2 Click Settings > Embedded Solutions > Solutions Management.
3 Under the appropriate application, click Update License.
4 In the Update License window, select Use a network license server.
5 Click Update License.
Configuring Eco-Settings using the Embedded Web Server
Configuring energy- and paper-saving options
1 Access the application configuration settings from the Embedded Web Server or MarkVision Professional.
2 Adjust the following settings as necessary:
• Eco Mode—Choose Off, Energy, Energy/Paper, or Paper.
Note: If your printer model supports duplex printing, then you will be able to print on both sides of the paper.
Choosing Energy/Paper will automatically set 2-Sided Printing and Sleep Mode to default values. Additional
changes made to these settings through the Embedded Web Server will be ignored.
• Standby Mode—Type the number of minutes (1–240) the printer waits before it enters Standby Mode.
• Sleep Mode or Power Saver—Type the number of minutes (1–240) the printer waits before it enters Sleep
Mode or Power Saver mode.
• Screen Brightness—Type a screen brightness percentage (20–100).
• 2-Sided Printing—Choose 1-Sided, 2-Sided Long Edge, or 2-Sided Short Edge.
• Darkness or Toner Darkness—Choose a toner darkness value (1–5).
• Quiet Mode—Select this check box to reduce the amount of noise produced by the printer.
Note: When this option is selected, printer engine motors do not start until a print job is ready to print. You
may notice a short delay before the first page is printed, as well as a reduction in processing speed.
• Lock UI—Select this check box to prevent users from changing Eco-Settings from the printer control panel.
3 Do one of the following:
Configuring the application
11
To Next Page
Loading...
