Lexmark CS410 Technical Reference Guide

Command Description Supported
DRP Draw to Relative Position Yes
DRPA Draw to Relative Position specified by Angle Yes
DUPX select or deselect DUPleX mode Yes
DXPG select DupleX PaGe side Yes
DZP Draw to Zero-relative Position Yes
ENDD
3
END Dump No
ENDM END Macro Yes
ENDR END Raster data Yes
EXIT EXIT from PRESCRIBE mode Yes
FILL
2
FILL closed path Yes
FLAT
2
set FLATness No
FLST
2
print Font LiST Yes
FONT change current FONT Yes
FPAT generate Fill PATtern Yes
FRPO
1
Firmware RePrOgram Yes
FRPO INIT FRPO INITialize Yes
FSET
2
change current Font SETting by characteristic Yes
FTMD bitmap FonT MoDe Yes
GENF
1
GENerate Font Yes
GPAT
2
set Gray PATtern Yes
ICCD
1, 2
read/write IC - CarD No
INTL InterNaTionaL characters Yes
LDFC LoaD Font Character Yes
MAP Move to Absolute Position Yes
MCRO define MaCRO Yes
MRP Move to Relative Position Yes
MRPA Move to Relative Position specified by Angle Yes
MZP Move to Zero-relative Position Yes
NEWP
2
start NEW Path Yes
PAGE start new PAGE Yes
1
Partial support or extended support (see next section for details)
2
PRESCRIBE II option
3
Not applicable (for example, unsupported paper option or diagnostic command)
4
Custom command extension, not part of standard PRESCRIBE language
PRESCRIBE commands 7

Lexmark CS410 Specifications

General

Print Technology	Color Laser
Print Resolution	1200 x 1200 dpi
Standard Memory	256 MB
Processor Speed	800 MHz
Standard Input Capacity	250 sheets
Connectivity	USB, Ethernet
Supported Operating Systems	Windows, Mac OS, Linux
Monthly Duty Cycle	75, 000 pages
Maximum Memory	2304 MB
Duplex Printing	Yes
Mobile Printing	Yes