• The largest supported Universal size is 216 x
356 mm (8.5 x 14 inches) for one‑sided and two‑sided printing.
1 From the home screen, navigate to:
> Paper Menu > Universal Setup > Units of Measure > select
a unit of measure
2 Touch Portrait Width or Portrait Height.
3 Select the width or height, and then touch .
Loading the 250 and 550‑sheet tray
The printer has one 250-sheet tray (Tray 1) with an integrated manual
feeder. The 250-sheet tray, the 650-sheet duo tray, and the 550-sheet
tray support the same paper sizes and types and are loaded in the same
way.
CAUTION—POTENTIAL INJURY: To reduce the risk of
equipment instability, load each tray separately. Keep all trays
closed until needed.
1 Pull out the tray completely.
Note: Do not remove trays while a job is printing or while Busy
appears on the display. Doing so may cause a jam.
2 If the paper is longer than letter‑size paper, then push the length
guide tab at the back of the tray to extend it.
2
1
3 Squeeze the length guide tab, and then slide the guide to the
correct position for the size of the paper being loaded.
1
2
Note: Use the size indicators on the bottom of the tray to help
position the guide.
4 Squeeze and slide the width guide to the correct position for the
size of the paper being loaded.
2
1
Note: Use the paper size indicators on the bottom of the tray to
help position the guides.
5 Flex the sheets back and forth to loosen them. Do not fold or crease
the paper. Straighten the edges on a level surface.
3
To Next Page
Loading...
