Jam locations
7 Finisher
• Booklet finisher
• Staple, hole punch finisher
Paper jam in the multipurpose feeder
1 Remove paper from the multipurpose feeder.
2 Remove the jammed paper.
Note: Make sure that all paper fragments are removed.
3 Open door C to remove any paper fragments.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a
hot component, allow the surface to cool before touching it.
Notes:
• Make sure that the door does not hit any cable attached to the printer.
• If a 3000‑sheet tray is installed, then slide the tray to the right to open the door.
4 Close the door.
5 Flex, fan, and align the paper edges before loading.
6 Reload paper.
Paper jam in door C
1 Open door C.
Clearing jams 132
To Next Page
Loading...
