Use To
PCL Emulation Settings
Auto CR after LF
On
O
Specify whether the printer automatically performs a carriage return (CR)
after a line feed (LF) control command.
Note:
O
is the factory default setting.
PCL Emulation Settings
Auto LF after CR
On
O
Specify whether the printer automatically performs a line feed (LF) after a
carriage return (CR) control command.
Note:
O
is the factory default setting.
Tray Renumber
Assign MP Feeder
O
None
0–199
Assign Tray [x]
O
None
0–199
Assign Manual Paper
O
None
0–199
Assign Manual Env
O
None
0–199
Configure the printer to work with printer software or programs that use
dierent source assignments for trays and feeders.
Notes:
• “O” is the factory default setting.
• “None” ignores the Select Paper Feed command. This option
appears only when it is selected by the PCL 5 interpreter.
• “0–199” allows a custom setting to be assigned.
Tray Renumber
View Factory Defaults
MPF Default = 8
T1 Default = 1
T1 Default = 4
T1 Default = 5
T1 Default = 20
T1 Default = 21
Env Default = 6
MPaper Default = 2
MEnv Default = 3
Display the factory default setting assigned to each tray or feeder.
Tray Renumber
Restore Defaults
Ye s
No
Restore all tray and feeder assignments to the factory default settings.
Understanding the printer menus 196
To Next Page
Loading...
