66
Operator panel codes
Font error
Host interface disabled
Light sequence:
• Continue—On
• Toner Low/Replace PC Kit—Blink
• Error—On
What this light sequence means:
The printer has received a request for a PPDS font which is not installed.
What you can do:
• Press and release Cancel to cancel the print job.
• Press and hold Cancel to reset the printer.
• Press Continue to clear the message and continue printing.
Light sequence:
• Continue—On
• Load Paper—Blink
• Paper Jam—Blink
• Error—On
What this light sequence means:
The printer USB or parallel port has been disabled.
What you can do:
• Press Continue to clear the message. The printer discards any print
jobs previously sent. Enable the USB or parallel port by selecting a value
other than Disabled for the USB Buffer or Parallel Buffer item in the Local
Printer Setup Utility (see Using the Local Printer Setup Utility).
To Next Page
Loading...
