1-6 Lexmark™ E250d and E250dn
4512-220, -230
Types of print media
Ensure trays are properly loaded. Never mix media types within a tray.
Source Sizes Types Weight
6
Input capacity
(sheets)²
Input tray 1
(250-sheet tray)
A4, A5, A6³, JIS B5,
letter, legal, executive,
folio, statement
Paper, labels¹,
transparencies
60—90 g/m
2
(16—24 lb)
250 paper
50 labels¹
50 transparencies
2nd Drawer option
(550-sheet only)
A4, letter, legal, A5, JIS
B5, executive, folio,
statement
Paper, labels¹,
transparencies
60—90 g/m
2
(16—24 lb)
550 paper (20 lb)
50 labels¹
50 transparencies
Manual feed input
7
A4, A5, A6³, JIS B5,
letter, legal, executive,
folio, statement
Paper, labels¹,
transparencies, card stock,
4
envelopes
5
60—163 g/m
2
(16—43 lb)
1 sheet (all medias)
Envelopes
5
:
monarch (7 3/4), 9, 10,
C5, B5, DL
Minimum feed size: 76 X
127mm
Universal (max) paper:
216 X 357mm (legal size)
¹ Single sided paper labels are supported for the occasional use of less than 20 pages per month. They must exit through
the rear door. Labels such as vinyl labels, pharmacy labels or dual-sided labels are not supported.
² For 20 lb print material, unless otherwise noted.
³ A6 long grain media supported/short grain A6 not supported
4
Card stock up to 90# index. Designed to exit rear door. Short grain is recommended.
5
20 lb envelopes are recommended
Wrinkling may also occur on the front side, but away from address or return address areas. Slight wrinkling (nit in address
areas) is permitted on 24# envelopes. Use envelopes that lay flat when individually placed on a table face-down. The
distance of any edge or corner from the table should be less than 3 mm.
6
This refers to paper only. Treeing may occur on 16# paper.
7
Input using manual feeder is reduced to 1/2 speed
To Next Page
Loading...
