Diagnostic information 2-31
4512-220, -230
201.02 Exit sensor never made by leading edge of page. Also known as internal jam.
201.03 Video never started on the page at the input sensor within two inches after hitting
the input sensor
201.05 Restart attempted after an internal jam without the cover open/close event. It is
likely that the jam was never cleared.
201.25 Exit sensor never made by leading edge of media when feeding out the media that
was detected during warm-up.
201.26 Page at fuser nip before fuser started ramping toward desired temperature.
Indicates code may be receiving more hall interrupts than intended
201.27 Page at fuser nip before fuser reached acceptable operating temperature. Page
arrived at fuser earlier than expected, so it was probably staged
202.00 Paper jam around exit sensor.
202.01 Exit sensor never broke on the trailing edge of the sheet at the exit sensor.
202.02 Exit sensor never broke from sheet ahead of page heading toward the exit sensor.
202.06 Exit sensor bounced
202.13 Exit sensor covered, media not expected (media not in machine during warm-up)
202.25 Exit sensor never broke from the sheet ahead of the page heading toward the exit
sensor when feeding out the media detected during warm-up.
202.26 Trailing edge never cleared exit sensor when feeding out media that was detected
during warm-up.
202.32 Long media or shingled multi feed stopped before sending to duplex.
231.00 Duplex jam while reversing into the device
231.01 Duplex sensor never made by leading edge reversing into the duplex. x1=sensor
state
231.02 Bouncy duplex sensor never made. x1+x2=paper path location
232.00 Duplex jam while staging in the device
232.01 Duplex sensor never broke by the sheet ahead after reversing into the duplex.
x1=sensor state, x2+x3=paper path location
232.02 Page in duplex ahead of current reversing page never staged. x1=duplex sensor
state (1=made), x2+x3=paper path location
233.00 Duplex jam while picking from the device
233.01 Page in duplex never picked. x1+x2=paper path location
233.02 Feed error picking from the duplex. x1=source, x2+x3=time since pick
233.03 Paper never reached the input sensor, but was detected at the manual feed
sensor.
234.01 Duplex sensor covered during warm-up.
235.01 Invalid duplex media
241.00 Paper jam near tray 1.
Paper jam error codes (Continued)
Error Description
To Next Page
Loading...
