Lexmark E260 Series User Manual

2 Lift and pull the unit containing the photoconductor kit and the toner cartridge out of the printer. Set the unit
aside on a flat, clean surface.
Warning—Potential Damage: Do not touch the photoconductor on the underside of the photoconductor kit.
Use the cartridge handle whenever you are holding the cartridge.
CAUTION—HOT SURFACE: The fuser and the inside of the printer near the fuser may be hot. To reduce the
risk of injury from a hot component, allow the surface to cool before removing paper from this area.
3 Remove the jammed paper.
Note: If the paper is not easy to remove, then open the rear door to remove the paper.
4 Align and reinstall the unit.
Clearing jams
119

Lexmark E260 Series Specifications

General

Print Technology	Monochrome Laser
Print Speed	Up to 35 ppm
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 50, 000 pages
Output Capacity	150-sheet output bin
Duplex Printing	Manual
Maximum Paper Size	8.5 x 14 inches
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Input Capacity	250-sheet input tray
Media Types Supported	Card Stock, Envelopes, Labels, Plain Paper, Transparencies
Media Sizes Supported	A4, A5, Letter, Legal, Executive, Folio, Statement
First Page Out Time	6.5 seconds
Recommended Monthly Page Volume	Up to 2500 pages
Weight	22.5 lbs