Menu item Description
Eco-Mode
Off
Energy
Paper
Energy/Paper
Note: Off is the factory default setting.
Quiet Mode
Off
On
Note: Off is the factory default setting.
Run Initial Setup
Yes
No
Before running the Setup Wizard, the default setting is Yes, but
after running the wizard, the default setting is No.
Alarm
Cartridge Alarm
Off
Single
The display shows a message when the toner is low
Notes:
• Off is the factory default setting. The Toner is low
message will appear as a warning.
• Single means the Toner is low message will appear and
the indicator light will blink red.
Timeouts
Power Saver
Disabled
1–240
Sets the amount of time in minutes the printer waits after a job is
printed before it goes into a reduced power state
Note: Disabled does not appear unless Energy Conserve is Off.
Timeouts
Print Timeout
Disabled
1–255
Sets the amount of time in seconds the printer waits to receive an
end-of-job message before canceling the remainder of the print
job
Notes:
• 90 seconds is the factory default setting.
• When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any new
print jobs are waiting.
• Print Timeout is available only when using PCL. This setting
has no effect on PostScript emulation print jobs.
Timeouts
Wait Timeout
Disabled
15–65535
Sets the amount of time in seconds the printer waits for additional
data before canceling a print job
Notes:
• 40 seconds is the factory default setting.
• Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL
emulation print jobs.
Understanding printer menus
78
To Next Page
Loading...
Need help?
General
