3 Grasp the handle, and pull the extension so it flips forward.
4 Guide the extension down gently so the multipurpose feeder
is extended fully and open.
Loading the multipurpose feeder
1 Squeeze the tab located on the right width guide, and move
the guides out fully.
2 Prepare the paper or specialty media for loading.
• Flex sheets of paper or paper labels back and forth to
loosen them, and then fan them. Do not fold or crease the
paper or labels. Straighten the edges on a level surface.
• Hold transparencies by the edges, and then fan them.
Straighten the edges on a level surface.
Note: Avoid touching the print side of the transparencies.
Be careful not to scratch them.
• Flex a stack of envelopes back and forth to loosen them,
and then fan them. Straighten the edges on a level surface.
Note: Fanning prevents the edges of envelopes from
sticking together. It also helps them feed properly to
avoid jams. Do not fold or crease envelopes.
3 Load the paper or specialty media.
Notes:
• Do not force any paper into the multipurpose feeder.
Overfilling may cause jams.
• Do not exceed the maximum stack height by forcing paper
or specialty media under the stack height limiters which
are located on the guides.
4