Place the unit on a flat, clean surface.
3 Press the button on the base of the photoconductor kit. Pull
the toner cartridge up and out using the handle.
4 Unpack the new photoconductor kit. Be careful not to touch
the photoconductor drum.
5 Insert the toner cartridge into the photoconductor kit by
aligning the rollers on the toner cartridge with the tracks. Push
the toner cartridge until it clicks into place.
6 Install the unit into the printer by aligning the arrows on the
guides of the unit with the arrows in the printer. Push the unit
as far as it will go.
7 After you replace the photoconductor kit, reset the
photoconductor counter. To reset the counter, see the
instruction sheet that came with the new photoconductor kit.
Warning—Potential Damage: Resetting the
photoconductor counter without replacing the
photoconductor may damage your printer and void your
warranty.
8 Close the front door.
Replacing the toner cartridge
When 88 Cartridge is low appears, or when you
experience faded print, remove the toner cartridge. Firmly shake
it side-to-side and front-to-back several times to redistribute the
toner, and then reinsert it and continue printing. When shaking
the cartridge no longer improves the print quality, replace the
toner cartridge.
Note: You can check to see approximately how much toner is left
in your cartridge by printing a menu settings page.
7
To Next Page
Loading...
Need help?
General
Weight and Dimensions
