4 Connect the power cord to a properly grounded outlet.
5 Turn the printer back on.
• Press to clear the message and continue printing.
58 Too many trays attached
1 Turn the printer off.
2 Unplug the power cord from the wall outlet.
Note: Optional trays lock together when stacked. Remove stacked trays one at a time from the top down.
3 Remove the additional trays.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer back on.
80 Routine Maintenance
The printer needs to have scheduled maintenance done. Order a maintenance kit, which contains a fuser and a
transfer roller. Contact Customer Support, and report the message.
84 PC Kit life warning
The photoconductor kit is near exhaustion.
Try one or more of the following:
• Replace the photoconductor kit.
• Press the up or down arrow button until Continue appears, and then press to clear the message and
continue printing.
84 Replace PC Kit
The photoconductor kit is exhausted. Install a new photoconductor kit.
88 Cartridge low
The toner is low. Replace the toner cartridge, and then press the up or down arrow button until Continue appears,
and then press
to clear the message and continue printing.
1565 Emulation error, load emulation option
The printer automatically clears the message in 30 seconds and then disables the download emulator on the firmware
card.
To fix this, download the correct download emulator version from the Lexmark Web site at www.lexmark.com.
Troubleshooting
145
To Next Page
Loading...
