c Tighten the two screws.
d Insert the plug of the printer hard disk interface cable into the receptacle of the controller board.
Note: The plug and the receptacle are color‑coded blue.
4 Close the controller board shield, and then close the access door.
Note: When the printer software and any hardware options are installed, you may need to manually add the
options in the printer driver to make them available for print jobs. For more information, see
“Adding
available options in the print driver” on page 29.
Removing a printer hard disk
Note: This option is supported only in MS610de printer model.
Additional printer setup 25
To Next Page
Loading...
