EasyManua.ls Logo

Lexmark MX510 Series - Replace Jammed Originals if Restarting Job

Lexmark MX510 Series
329 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Replace defective imaging unit [31.xy]
Replace the defective imaging unit to clear the message. For more information, see the instruction sheet that came
with the supply or see the “Replacing supplies” section of the User’s Guide.
Note: If you do not have a replacement imaging unit, then see the “Ordering supplies” section of the User’s Guide or
visit
www.lexmark.com.
Replace imaging unit, 0 estimated pages remain [84.xy]
Replace the imaging unit to clear the message and continue printing. For more information, see the instruction sheet
that came with the supply or see the “Replacing supplies” section of the User’s Guide.
Note: If you do not have a replacement imaging unit, then see the “Ordering supplies” section of the User’s Guide or
visit
www.lexmark.com.
Replace jammed originals if restarting job.
From the printer control panel, try one or more of the following:
Select Cancel job to clear the message and cancel the scan job. For nontouchscreen printer models, press
to confirm.
Select Scan from automatic feeder to continue scanning from the ADF immediately after the last successful scan
job. For nontouchscreen printer models, press
to confirm.
Select Scan from flatbed to continue scanning from the scanner immediately after the last successful scan job. For
nontouchscreen printer models, press
to confirm.
Select Finish job without further scanning to end the last successful scan job. For nontouchscreen printer models,
press
to confirm.
Select Restart job to restart the scan job with the same settings from the previous scan job. For nontouchscreen
printer models, press
to confirm.
Replace maintenance kit, 0 estimated pages remain [80.xy]
Contact customer support at http://support.lexmark.com or your service representative, and then report the message.
The printer is scheduled for maintenance.
Replace unsupported cartridge [32.xy]
Remove the toner cartridge, and then install a supported one to clear the message and continue printing. For more
information, see the instruction sheet that came with the supply or see the “Replacing supplies” section of the User’s
Guide.
Note: If you do not have a replacement cartridge, then see the “Ordering supplies” section of the User’s Guide or
visit
www.lexmark.com.
Troubleshooting 251

Table of Contents

Related product manuals