Lexmark MX532 - Page 52

• Korean
• Arabic
– Mass storage
• Hard disk
• Licensed features
– IPDS
– Bar Code
• Internal solutions port
– RS-232C Serial Interface Card
– Parallel 1284-B Interface Card
– MarkNet
TM
N8230 Fiber Ethernet
Note: An intelligent storage drive or a hard disk is required to activate Forms Merge and some IPDS features.
Installing optional trays
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller
board or installing optional hardware or memory devices sometime after setting up the printer, then turn
the printer o, and unplug the power cord from the electrical outlet before continuing. If you have any
other devices attached to the printer, then turn them o as well, and unplug any cables going into the
printer.
1 Turn
o
the printer.
2 Unplug the power cord from the electrical outlet, and then from the printer.
3 Unpack the optional tray, and then remove all packing material.
4 Align the printer with the optional tray, and then lower the printer into place.
CAUTION—POTENTIAL INJURY: If the printer weight is greater than 20 kg (44 lb), then it may
require two or more people to lift it safely.
Set up, install, and configure 52