3 Slide the width guide to the correct position for the size of the paper
you are loading.
Note: Use the paper size indicators on the bottom of the tray to
help position the guides.
4 Prepare the paper or specialty media for loading.
• Flex the sheets back and forth to loosen them, and then fan
them. Do not fold or crease the paper. Straighten the edges on
a level surface.
• Hold transparencies by the edges, and then fan them.
Straighten the edges on a level surface.
Note: Avoid touching the printable side of the
transparencies. Be careful not to scratch them.
• Flex the stack of envelopes back and forth to loosen them, and
then fan them. Straighten the edges on a level surface.
5 Load the paper or specialty media.
Note: Slide the stack gently into the multipurpose feeder until it
comes to a stop.
• Load only one size and type of paper or specialty media at a
time.
• Make sure the paper fits loosely in the multipurpose feeder,
lies flat, and is not bent or wrinkled.
One‑sided (simplex) printing Two‑sided (duplex) printing
ABC
12
To Next Page
Loading...
