To use the application, touch Scan to Network on the printer home
screen, and then follow the instructions on the printer display.
Setting up Remote Operator Panel
This application enables you to interact with the printer control panel
even when you are not physically near the network printer. From your
computer, you can view the printer status, release held print jobs,
create bookmarks, and do other print-related tasks.
1 Open a Web browser, and then type the printer IP address in the
address field.
Note: View the printer IP address on the printer home screen.
The IP address appears as four sets of numbers separated by
periods, such as 123.123.123.123.
2 Click Settings > Remote Operator Panel Settings.
3 Select the Enable check box, and then customize the settings.
4 Click Submit.
To use the application, click Remote Operator Panel > Launch VNC
Applet.
Exporting and importing a configuration
You can export configuration settings into a text file, and then import
the file to apply the settings to other printers.
1 Open a Web browser, and then type the printer IP address in the
address field.
Note: View the IP address on the printer home screen. The IP
address appears as four sets of numbers separated by periods,
such as 123.123.123.123.
2 Export or import a configuration file for one or multiple
applications.
For one application
a Navigate to:
Settings > Apps > Apps Management > select an application >
Configure
b Export or import the configuration file.
Notes:
• If a JVM Out of Memory error occurs, then repeat
the export process until the configuration file is saved.
• If a timeout occurs and a blank screen appears, then
refresh the Web browser, and then click Apply.
For multiple applications
a Click Settings > Import/Export.
b Export or import a configuration file.
Note: When importing a configuration file, click Submit to
complete the process.
Loading paper and specialty
media
Setting the paper size and type
From the home screen navigate to:
> Paper Menu > Paper Size/Type > select a tray > select the paper
size or type >
Configuring Universal paper settings
Universal paper size is a user‑defined setting that lets you print on
paper sizes that are not preset in the printer menus.
Notes:
• The smallest supported Universal size is
70 x 127 mm (2.76 x 5 inches) for one‑sided printing and
105 x 148 mm (4.13 x 5.83 inches) for two‑sided (duplex)
printing.
• The largest supported Universal size is 216 x
356 mm (8.5 x 14 inches) for one‑sided and two‑sided printing.
• When printing on paper less than 210 mm (8.3 inches) wide, the
printer may print at a reduced speed after a period of time to
ensure the best print performance.
1 From the home screen, navigate to:
> Paper Menu > Universal Setup > Units of Measure > select
a unit of measure
2 Touch Portrait Width or Portrait Height.
3 Select the width or height, and then touch Submit.
Loading the 250‑ or 550‑sheet tray
CAUTION—POTENTIAL INJURY: To reduce the risk of
equipment instability, load each tray separately. Keep all other
trays closed until needed.
1 Pull out the tray.
Notes:
• When loading folio‑, legal‑, or Oficio‑size paper, lift the tray
slightly, and then pull it out completely.
• Avoid removing trays while a job prints or while Busy
appears on the display. Doing so may cause a jam.
5
To Next Page
Loading...
