PJL
3-39
LPPDS
(DEFAULT only)
Activate
Personal Printer
Data Stream
(PPDS) printer
language
ON, OFF
Use ON to enable PPDS printer language and OFF to
disable PPDS printer language. After this command is
processed, the printer performs a Power On Reset
(POR) to activate the changes.
Note: The following printer settings in NVRAM are
changed when PPDS is activated:
• PCL and PS SmartSwitch settings for each port are
turned off
• Printer Language is set to PPDS
OFF
LPPDSFORMLINES
(DEFAULT only)
Lines Per Page
(PPDS)
1 to 255 64, 68
(Country specific)
LPPDSLINESPERINCH
(DEFAULT only)
Lines Per Inch 0.25 to 30.00 in increments of 0.25
Note: If a Lines Per Inch setting outside this range is
specified, the printer defaults to the closest number in
the range.
6.00
LPREPRINTEDLENGTH
(DEFAULT only)
Preprinted
Paper Length
NORMAL, SHORT NORMAL
LPREPRINTEDLOADING
(DEFAULT only)
Preprinted
Paper Loading
OFF, DUPLEX OFF
Table 3-4: Printer Unique Variables for Both Printer Languages (Continued)
Variable Function Selections Factory Default
To Next Page
Loading...
Need help?
General