PCL
2-56
GL/2 Commands
Note: GL/2 is not a stand-alone plotter emulation. It can only be entered from within
PCL emulation and cannot be used with software without a unique printer
driver written explicitly for GL/2.
The following tables list the GL/2 commands by group. To determine which GL/2
commands your printer supports, see Table A-2: “GL/2 Commands” on page A-7.
Table 2-35: Miscellaneous Commands
Command / Parameters Function / Result
ESC
&s#C
0 Enable
1 Disable (Default)
End-Of-Line Text Wrap
Enabling End-Of-Line Text Wrap moves portions of lines that extend
into the unprintable area to the next line. Disabling drops the portion
extending into the unprintable area.
ESC
Y Display Functions On
Prints all control codes and escape sequences rather than executing
them.
Notes:
• To prevent characters from falling outside the right margin (and not
printing), enable End-Of-Line Text Wrap (
ESC
&s0C).
• To see the control characters and other blank codepoints in symbol
set Roman8 (8U), set the symbol set to PC-8 (10U).
ESC
Z Display Functions Off
Turns off Display Functions; resumes normal command processing.
Table 2-36: Configuration Group
Command / Parameter Command Name
CO "text" Comment
DF; Default Values
IN (n); Initialize
IP (X
P1
,Y
P1
(, X
P2
,Y
P2
)); Input P1 and P2
IR (X
P1
,Y
P1
(, X
P2
,Y
P2
)); Input Relative P1 and P2
IW (X
1
,Y
1
,X
2
,Y
2
); Input Window
MC (mode(, opcode)); Logical Operation
PP (mode); Pixel Placement