PJL
3-87
The filename for a font is a five digit ID from the print directory page (add zeros to the
left of the ID to fill the five digits) followed by a three digit instance number. The first
time a font is downloaded after a flash has been formatted, the instance number is 0.
Filetypes are described under
filename in Table 3-9 “Printer Unique LRESOURCE
Variables” on page 3-50. For example, to write password protect a PCL emulation
bitmapped font (filetype of
p5bitmap)withanIDof127, which has not been
downloaded since flash was formatted:
@PJL DEFAULT LRESOURCE:"flash:00127000.p5bitmap"
LWLOCK="
password"[<CR>]<LF>
To password protect a macro, the filename is the ID taken from the print directory
page, followed by the filetype. For example, to read/write password protect a
PCL emulation macro (filetype is
p5macro)savedtoflashwithanIDof1023:
@PJL DEFAULT LRESOURCE:"flash:1023.p5macro" LRWLOCK="password"[<CR>]<LF>
Note: If the filename is incorrect, the printer applies the password to the entire
device.
Password for an Entire Device
If you want to set a password on a device, not just a single file, omit the filename.
LRWLOCK with DEFAULT specified locks a device for reading and writing. LWLOCK
with DEFAULT specified locks a device for writing only.
Syntax:
@PJL DEFAULT LRESOURCE:"device:" LRWLOCK="password"[<CR>]<LF>
@PJL DEFAULT LRESOURCE:"device:" LWLOCK="password"[<CR>]<LF>
To Next Page
Loading...
Need help?
General