Introduction
1-2
The Technical Reference is divided into the following:
Chapter 2: PCL Emulation
Shows how to select PCL emulation and discusses PCL emulation commands, GL/2
commands, and resident font and symbol set support.
Chapter 3: Printer Job Language
Contains detailed information about certain commands that cause the printer to enter
PCL emulation, PostScript emulation, and Personal Printer Data Stream (PPDS), and
many other types of commands.
Chapter 4: PostScript Emulation
Provides information about PostScript emulation and explains PostScript emulation
supplemental operators.
Chapter 5: Switching Languages
Describes ways to switch printer languages and explains when you may want to
choose one method over another.
Chapter 6: Flash Memory and Disk
Provides information about using the flash memory and hard disk. It describes how to
manage printer memory, store resources (such as fonts and macros), and manage
files.
Chapter 7: Printer Specifications
Lists printer specifications, including information about hardware and environmental
conditions.
Chapter 8: Printer Interfaces
Provides information on printer interfaces, including information about parallel and
serial interface, network support, and communication protocols.