PJL
3-18
POWERSAVETIME
(DEFAULT only)
Power Save time,
in minutes
0 to 120 (Model specific)
1 to 240 (Model specific)
The time the printer remains idle before it enters
Power Save mode when POWERSAVE is On.
Note: If a value greater than 120 or 240 is specified by
a SET or DEFAULT command, the value is changed to
120 or 240 based on the printer model.
20
QTY
(SET only)
Collation -
Collated Copies
(QTY)
0to999
Used to request the number of collated copies of a
print job.
If Collation - Collated Copies (QTY) is not equal to 0, a
DINQUIRE or INQUIRE returns the numerical setting
for QTY. If Collation - Collated Copies (QTY) is set to
Off, a DINQUIRE or INQUIRE returns 0.
Note: If a value greater than 999 is specified by a SET
or DEFAULT command, the value is changed to 999.
0
REPRINT Jam Recovery ON, OFF, AUTO AUTO
RESOLUTION Print Resolution 300, 600, 1200 600
RESOURCESAVE
(DEFAULT only)
Resource Save ON, OFF, AUTO
ON indicates Resource Save is set On.
OFF and AUTO indicate Resource Save is set to Off.
See Table B-1: “Common Variables for Both Printer
Languages” on page B-1 for the default value of your
printer.
OFF, AUTO
(Model specific)
RET Print Quality
Enhancement
Technology
(PQET)
OFF, DARK, MEDIUM, LIGHT, ON
If this value is set through PJL, the same value is
returned on a PJL inquiry.
DARK, MEDIUM, LIGHT, and ON values indicate that
PQET is On. OFF indicates PQET is Off.
ON
TIMEOUT Print timeout,
in seconds
0to255
The time the printer remains idle before the job is
forced to print.
Note: If a value greater than 255 is specified by a SET
or DEFAULT command, the value is changed to 255.
90
USERNAME
(SET only)
Print and Hold
Username
“username”
username is a text string truncated to 24 characters.
Note: A null (“ “) string is an acceptable value and
indicates no Print and Hold Username is specified.
NULL
(no username)
WIDEA4 A4 width NO, YES
NO indicates the A4 width is 198 mm.
YES indicates the A4 width is 203 mm.
NO
Table 3-3: Common Variables for Both Printer Languages (Continued)
Variable Function Selections Factory Default
To Next Page
Loading...
Need help?
General