Page 6 of 8
Loading a tray
Load print media into any of the standard or optional trays. All trays are loaded the same way.
1 Remove the tray.
2 Squeeze the width guide tab and the width guide, and slide the guide to the far right side of the tray.
3 Squeeze the length guide lever, and slide the length guide to the correct position for the size paper you are
loading.
4 Place the print media into the tray with the recommended print side face down for single-sided printing and
face up for double-sided printing. Do not load print media above the load line.
5 Squeeze the width guide tab and the width guide, and slide the width guide to the left until it lightly rests
against the edge of the paper stack.
Squeeze
Width
guide
Size indicators
Length
guide
Width guide
tab
To Next Page
Loading...
