Replace wiper
Try one or more of the following:
• Replace the fuser wiper.
• Press the arrow buttons until Continue appears, and then press to clear the message and continue printing.
Resetting active bin
Wait for the message to clear.
Resetting the printer
Wait for the message to clear.
Resetting without replacing may affect print quality.
You selected No from the “Verify PC unit replaced” screen. Wait for the message to clear.
Restoring Factory Defaults
Wait for the message to clear.
When factory default settings are restored:
• All downloaded resources in the printer memory are deleted. This includes fonts, macros, and symbol sets.
• All settings return to the factory defaults except the Display Language setting in the Setup menu and the custom
settings in the Serial <x>, Network, Infrared, LocalTalk, and USB menus.
Restore Held Jobs?
Try one of the following:
• Press the arrow buttons until Continue appears, and then press to restore all held jobs stored on the printer
hard disk.
• Press the arrow buttons until Do not restore appears, and then press . No print jobs will be restored.
Restoring Held Job(s) x/y
x represents the number of jobs being restored. y represents the total number of jobs to be restored.
Try one or more of the following:
• Wait for the message to clear.
• Press the arrow buttons until Quit restoring appears, and then press to delete unrestored held jobs.
Understanding printer messages 157
To Next Page
Loading...
