4 Press the arrow buttons until Auto Fax Convert appears, and then press .
5 If auto fax conversion is not set to on, press the arrow buttons until On appears, and then press .
Remote Fax Error
These are possible solutions. Try one or more of the following:
CHECK THE PHONE LINE
Resend the fax. There may have been a problem with the quality of the telephone line connection.
DECREASE THE TRANSMISSION SPEED
1 From the printer control panel, press .
2 Press the arrow buttons until Fax Setup appears, and then press .
3 Press the arrow buttons until Dialing and Sending appears, and then press .
4 Press the arrow buttons until Max Send Speed appears, and then press .
5 Press the arrow buttons to select a lower transmission speed, and then press .
6 Resend the fax.
7 If the problem persists, repeat step 1 through step 5 to resend the fax at successively lower transmission speeds.
Note: 2400 bps is the lowest transmission speed.
Notes:
• The lower the transmission speed, the longer it will take your fax to print.
• This solution will reduce the speed for future faxes until you reset the transmission speed.
Phone Line Busy
These are possible causes and solutions. Try one or more of the following:
CHANGE REDIAL SETTINGS
The printer automatically redials three times at two-minute intervals. You can change the default settings to redial
up to five times at intervals up to eight minutes.
To change the redial settings:
1 From the printer control panel, press .
2 Press the arrow buttons until Dialing and Sending appears, and then press .
3 To change the number of times the printer will redial:
a Press the arrow buttons until Redial Attempts appears, and then press .
b Press the arrow buttons until the setting that you want appears, and then press .
Troubleshooting
150
To Next Page
Loading...
Need help?
General
