1 Press the tray release latch to the left, and then pull the
multipurpose feeder down.
2 Gently pull the extension out until it is fully extended.
3 Flex the sheets back and forth to loosen them. Do not fold or crease
the paper. Straighten the edges on a level surface.
Paper
Envelopes
Transparencies*
* Avoid touching the printable side of transparencies. Be careful not
to scratch them.
4 Load the paper or specialty media. Slide the stack into the
multipurpose feeder until it comes to a stop.
Notes:
• Make sure paper or specialty media does not exceed the
maximum paper fill indicator.
• Load only one size and type of paper or specialty media at a
time.
• Paper or specialty media should lie flat and fit loosely in the
multipurpose feeder.
• If the paper or specialty media is pushed too far into the
multipurpose feeder, then press the paper release lever to
remove it.
• Load envelopes with the flap on the right side up and the
stamp edge entering the printer first.
Warning—Potential Damage: Never use envelopes with stamps,
clasps, snaps, windows, coated linings, or self‑stick adhesives.
These envelopes may severely damage the printer.
5 From the printer control panel, verify the paper size and paper type
setting for the feeder based on the paper you loaded.
12
To Next Page
Loading...
