From here You can
Prompt to name each page Enter a filename for every page or item scanned.
Defaults Revert to factory default settings.
Preview/Edit Open the Scan dialog to view the image, and adjust the scan settings.
Scan Start scanning.
Click to go to the Help Center for more information.
Related topics:
• “Scanning” on page 44
• “Working with photos using the computer” on page 99
Using the Network Card Reader
When you have a memory device inserted into the printer, the Network Card Reader software lets you connect to a
network printer, display thumbnails of the photos or images on the memory device, and transfer the images to the
computer.
There are three ways to open the Network Card Reader:
• From the Finder desktop, double-click the Lexmark 7500 Series folder.
Double-click the Lexmark Network Card Reader icon.
• Go to the Mac OS X drive where the printer software was installed.
Choose Library Printers Lexmark Lexmark 7500 Series folder.
Double-click the Lexmark Network Card Reader icon.
• Insert a memory card or flash drive into the printer.
1 After the memory device is detected, press .
2 Press repeatedly until Save Photos is highlighted.
3 Press .
4 Press or until Computer appears.
5 Press .
If there is more than one computer connected to the network, you will be asked to select the computer that
you want to use.
a Press or to select a computer.
b Press .
If you set a PIN during network setup and are being asked for it:
1 Enter the PIN using the and to select a digit location and the and to select a value for
that digit.
2 Press .
c Press to begin saving photos to the computer.
The Network Card Reader dialog appears on the computer screen.
Understanding the printer
140
To Next Page
Loading...
