Lexmark X7550 - Adjusting the Brightness of a Copy; Copying Photos

5 Press .
6 Press repeatedly until Color is highlighted.
7 Press or to choose Color or Black & White.
8 Press to preview the copy.
9 Press to continue adjusting the settings.
10 Repeat step 8 to step 9 as needed.
11 Press to save your settings temporarily.
12 Press .
Adjusting the brightness of a copy
1 Load paper.
2 Load an original document facedown on the scanner glass.
3 From the control panel, press or repeatedly until Copy is highlighted.
4 Press or to select the number of copies.
The number of copies is automatically set to 1.
5 Press .
6 Press repeatedly until Lighter/Darker is highlighted.
7 Press or to adjust the brightness of the copy.
8 Press to preview the copy.
9 Press to continue adjusting the settings.
10 Repeat step 8 to step 9 as needed.
11 Press to save your settings temporarily.
12 Press .
Related topics:
• “Loading original documents on the scanner glass” on page 34
• “Using the control panel” on page 113
Copying photos
1 Load photo paper with the glossy or printable side facing you. (If you are not sure which side is the printable
side, see the instructions that came with the paper.)
2 Place a photo facedown on the scanner glass.
3 From the control panel, press or repeatedly until Copy is highlighted.
4 Press or to select the number of copies.
The number of copies is automatically set to 1.
Copying
38