Troubleshooting
Setup troubleshooting
Incorrect language appears on the display
These are possible solutions. Try one of the following:
Change the language selection during initial setup
After you select a language, Language appears again on the display. To change the selection:
1 Press or repeatedly until the language you want appears on the display.
2 Press to save.
Select a different language after initial setup
1 From the control panel, press repeatedly until Setup is highlighted.
2 Press .
3 Press repeatedly until Change Printer Default Settings is highlighted.
4 Press .
5 Press repeatedly until Language is highlighted.
6 Press or repeatedly until the language you want appears on the display.
7 Press to save.
8 Press to select Yes when the display asks Are you sure?
Power button is not lit
These are possible solutions. Try one or more of the following:
Press power button
Make sure the printer is on by pressing .
Troubleshooting
155
To Next Page
Loading...
