Lexmark X83 - 4403 XXX; Gear Train Assembly Removal; Access Cover Sensor Removal

4-6 Service Manual
4403-XXX
Gear Train Assembly Removal
1. Remove the CCD module assembly.
2. Disconnect the gear train assembly cable from the system
board.
3. Remove two screws [A].
4. Lift and remove the gear train assembly.
Access Cover Sensor Removal
1. Remove the top housing assembly.
2. Disconnect the access cover sensor cable (J10) from the
system board.
3. Remove the sensor screw.
4. Remove the sensor. Note routing of cables.