Lexmark X83 - Creating Projects

Repair Information 4-13
4403-XXX
Carrier Removal
1. Remove the rear cover.
2. Remove the top housing assembly.
3. Remove the left and right covers.
4. Disconnect the carrier cable from the system board.
5. Loosen the set screw on the carrier belt tensioner.
6. Depress the belt tensioner and remove the belt from the
transport carrier motor gear.
7. Remove both retainer clips from the carrier shaft.
8. Remove the shaft and carrier.
Note:
– Keep dirt and grease off the encoder strip.
– Observe orientation of the encoder strip to the sensor,
located on the rear of the carrier.
– Be careful not to damage the encoder strip when reinstalling
in the carrier.
Encoder Strip Removal
1. Remove the carrier assembly.
2. Depress the encoder strip clip.
3. Remove the encoder strip.
Maintenance Station Removal
1. Remove the middle frame assembly.
2. Remove the print engine.
3. Depress the two clips [A].