Card stock and label guidelines
When printing on labels:
• Set the paper type to Labels in the Paper Menu.
• Do not use label sheets with a slick backing material.
• Do not print within 1 mm (0.04 in.) of the die-cut, the edge of the label or the perforations, or between the die-
cuts.
• Use full label sheets. Partial sheets may cause labels to peel off during printing and result in a paper jam.
• Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive
at least 1 mm (0.04 in.) away from the edges. Adhesive material may contaminate your printer and could void your
warranty.
When printing on card stock:
• Use grain long card stock, and set the paper type to Card Stock.
• Do not use creased card stock. It may cause paper jams.
Lexmark X950
Limit label printing to occasional use of A4‑ or letter‑size paper office labels designed for laser printers. We do not
recommend using vinyl or polyester labels.
Lexmark X950 supports card stock up to 300 g/m
2
.
The following table lists the maximum weights supported by the trays and the multipurpose feeder.
Overview of card stock and label support
Trays 1–4 Multipurpose feeder High‑capacity feeder
Labels
60–256 g/m
2
60–300 g/m
2
60–216 g/m
2
Card stock
60–256 g/m
2
60–300 g/m
2
60–216 g/m
2
Printer specifications 150
To Next Page
Loading...
Need help?
General
Weight and Dimensions
